with the Manual insert the message showing on the icon as connected, is as followsīut I get a message Server Not Found.when I try to search with Google.Īlso. Would this be the "something else" that you mentioned? regarding not being found by DHCP.ģ. in the above pic there is a small box at the bottom which says "Require IPV4 addressing for this connection to complete" The driver on the Toshiba ( with the problem) is showing as the "new" driver r8101 but the driver on the ASUS is showing Ģ. I put 255.255.255.0 in the Net Mask Column.but it has changed to 24 for some reason! don`t know if I am doing the right thing.ġ. MisterW has pointed at the driver, and from the linky he provided, it seems it`s been a bit of a problem with I have done a MANUAL insert of the IP address Both installs were from a new download and done within 24 hours of each other. I don`t think the install of mint is corrupted, as it was run from the same Live USB as for the main ASUS laptop. ( which had no problems running mint or wired connection! ) and never had this problem UNTIL I got this Toshiba Satellite Pro 12 inch, to replace a 10 inch laptop. I have changed the Main board, on which the LAN socket is, for two others,Īny suggestions to solve the above problem would be appreciated. On the IPV4 section Using the same IP address Using the same Interface name for the router I have copied the same information from the Asus to the Toshiba on the "Editing Wired Connections" page. Icon shows "broken" connection and Ethernet Network "disconnected" I have disabled WIFI but kept Networking enabled I have been through the BIOS settings to make sure that LAN is enabled ( has always been, as far as I know ! ). Toshiba 12inch Satellite Pro will not connect via the (same) ethernet cable but will connect via WIFI. (and new ethernet cables ) Works really good.On the Asus. Router is upstairs, and connection to it, is via Power Plug adapters. connects to the internet via Ethernet and also via WIFI. both running Linux Mint 21.2 Vera - Mate editionĪsus Laptop. I would have thought that this would work, but it doesn't.Two Laptop. Resources: irq:18 ioport:c800(size=256) memory:fb9ff000-fb9ff0ff memory:f0200000-f021ffffĬonfiguration: broadcast=yes driver=rt73usb driverversion=2.6.35-28-generic firmware=N/A ip=192.168.1.102 link=yes multicast=yes wireless=IEEE 802.11bgĬonfiguration: broadcast=yes multicast=yes Resources: irq:50 ioport:9e00(size=256) memory:fbdff000-fbdfffff memory:fbdf8000-fbdfbfff memory:fbd00000-fbd1ffffĬapabilities: pm bus_master cap_list rom ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd 1000bt 1000bt-fd autonegotiationĬonfiguration: autonegotiation=on broadcast=yes driver=r8169 driverversion=2.3LK-NAPI duplex=half latency=64 link=no maxlatency=64 mingnt=32 multicast=yes port=MII speed=10MB/s Product: RTL8111/8168B PCI Express Gigabit Ethernet controllerĬapabilities: pm msi pciexpress msix vpd bus_master cap_list rom ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd 1000bt 1000bt-fd autonegotiationĬonfiguration: autonegotiation=on broadcast=yes driver=r8169 driverversion=2.3LK-NAPI duplex=full latency=0 link=no multicast=yes port=MII speed=100MB/s TX packets:50852 errors:0 dropped:0 overruns:0 carrier:0 RX packets:77043 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 TX packets:164 errors:0 dropped:0 overruns:0 carrier:0 RX packets:164 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0Įth1 Link encap:Ethernet HWaddr 94:0c:6d:80:aa:c4 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 Eth0 Link encap:Ethernet HWaddr 6c:f0:49:0f:c2:c7
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |